5975T GC/MSD
The Agilent 5975T LTM GC/MSD is a transportable GC/MSD system that delivers the same performance, reliability and quality results as a bench top. Agilent’s proprietary LTM technology is used for faster GC analysis by providing dramatically faster temperature ramp rates (up to 1200°C/minute). DRS and RTL databases are leveraged for faster screening and analysis of compounds in the field. The 5975T incorporates an anti-vibration base for safer transport.
Availability: DISCONTINUED
+1 816 427 5510
5301 Stevens Creek Boulevard
Santa Clara, CA 95051
USA
|
|
www.agilent.com
| Manufacturer |
| Agilent Technologies |
| Product Name |
| 5975T GC/MSD |
| Detection Category |
| Chemical; Explosives |
| Detection Principle |
| Spectrometry; Chromatography; |
| Detection Method |
| Quadrupole Mass Spectrometry; |
| Application |
| Laboratory Analysis; Trace Analysis; |
| Equipment Type |
| Instrument |
| Product Synopsis |
| The Agilent 5975T LTM GC/MSD is a transportable GC/MSD system that delivers the same performance, reliability and quality results as a bench top. Agilent’s proprietary LTM technology is used for faster GC analysis by providing dramatically faster temperature ramp rates (up to 1200°C/minute). DRS and RTL databases are leveraged for faster screening and analysis of compounds in the field. The 5975T incorporates an anti-vibration base for safer transport. |
| Availability |
| DISCONTINUED |
| Technology Readiness Level (TRL) |
| 9 |
| User Feedback Sources |
| Hands-on experience |
| Dimensions |
| 26 x 24 x 19 in (650 x 610 x 490 mm) |
| Weight |
| >50 lbs.; 125 or 150 lb (57 or 68 kg), depending on configuration |
| Power Requirements |
| AC/DC Line Power; 120 V AC |
| Noise Produced |
| None |
| Transportability |
| Benchtop/Fixed; Small Footprint |
| Ruggedness |
| None |
| Operating Conditions |
| 10 to 40°C (50 to 105°F); 40 to 80% RH |
| Consumables |
| >$1,000/year; Chromatography supplies (ferrules, GC columns, nuts, carrier gas, etc.). Mass spectrometry supplies (forepump oil, filaments, gaskets, O-rings, etc.) |
| Solvents/Reagents |
| None |
| Calibration Schedule |
| Yes |
| Suggested Routine Maintenance |
| Typical for benchtop GC/MS system—replace filament, change roughing pump oil |
| Shelf Life |
| >5 years |
| Unit Cost |
| $100,000.00 |
| Maintenance Cost |
| $3,000/year |
| Tested For Chemical Agents |
| Amenable based on technology |
| Tested For ITF-25 TIC/TIMs |
| Amenable based on technology |
| Tested For Explosives |
| Amenable based on technology |
| Tested For Narcotics |
| Amenable based on technology |
| Other Chemical Targets |
| Applicable to all organic compounds amenable to GC |
| Adaptability |
| Yes; user can add new targets in the field |
| Sample Introduction |
| Liquid; Vapor/Gas |
| Sensitivity/Detection Limits |
| ng |
| Known Interferents/Inhibitors |
| GC/MS is highly selective for volatile and semivolatile organic compounds when used by a skilled operator. Low false positive/negative rates for target analytes. False IDs are more likely for unknowns (nontargets) since GC retention times cannot be compared to reference RTs. |
| False Positive Rates |
| <1% |
| False Negative Rates |
| <1% |
| Start Up Time (From Cold Start To Sample Ready) |
| 4 hours |
| Response Time (Sample Application To Output) |
| >15 minutes; 5 to 45 minutes |
| Alarm Capability |
| Audible and visual |
| Software Control |
| Desktop computer |
| Training Required |
| >1 week training |
| Training Available |
| 1 to 2 weeks training recommended. On-going training recommended |
| Manuals Available |
| Operator's manual |
| Warranties |
| 1 year (extended warranties available) |
| IATA Shipping Restrictions |
| Yes; Compressed gas cylinders must be shipped ground only according to IATA regulations. |
